Table of Contents
Advertisement
Page 104 of 126
Table 75
IP Client Firmware menu
Command
start
end
stype
cache
comment
del
NN10300-091
Standard 1.00
Configuration menu
firmware to be supported, the version string needs to match a string between
the start and end strings listed in the table. The table is traversed in a
top-down fashion and on string overlaps the first match is used.
Table 76 identifies and describes the IP Client Firmware menu commands.
Description
Specifies the starting version string for the firmware version range to be
used for matching. This consists of seven characters and is 0602B76 for
Phase 0/1 phones.
Specifies the ending version string for the firmware version range to be
used for matching. If you do not specify an end version string, all versions
above the starting version string are matched and the firmware version is
0602B76 - 0602BZZ for Phase 0/1 phones, which supports both the current
image and later images.
Note: The last two characters in these strings differentiate the phone
images.
Specifies the server type used for matching IP phone firmware. Currently,
the choices are cs1k and mcs. For SMC 1.0, Nortel recommends that you
use the default of cs1k because mcs does not officially support Secure
UNIStim phone images.
Enables or disables session caching. If enabled, the firmware image
correctly supports session caching and the SMC tries to enable session
caching for these phones. If disabled, this firmware image does not
adequately support session caching.
Note: An example of a firmware image that does not adequately support
session cashing is image 0602B76.
Specifies a comment for this firmware image. The comment can identify of
the type of phone to which this image refers.
Deletes this IP client firmware entry from the table.
May 2006
Advertisement
Table of Contents
