Table of Contents
Advertisement
Page 74 of 126
Configuration menu
Port menu
Table 49
Port menu (/cfg/net/port)
Command
autoneg on | off
speed <port speed>
mode full | half
Interface menu
NN10300-091
Standard 1.00
Using the Port menu (/cfg/net/port <port_name>), you can configure the port
characteristics for a specified port.
Table 49 identifies and describes the Port menu commands.
Description
Enables or disables link auto-negotiation. If auto-negotiation is
disabled, the port operates at the speed set in the port speed
command.
Note: Enabling or disabling auto-negotiation can cause
temporary interruption to network traffic on all ports.
Specifies the link speed of the port. Enter the port speed as an
integer representing megabytes per second (MB/s). For Fast
Ethernet ports, you can set the speed to 10 or 100. For Gigabit
Ethernet ports, the speed is fixed at 1000.
Sets the port duplex mode to either full-duplex or half-duplex
mode. The default setting is full.
Using the Interface menu (/cfg/net/if), you can configure IP address interfaces
for the SMC. Each IP address interface represents a network attached to the
SMC.
To ensure traffic flows through the SMC, configure the network device
attached to an SMC port to use an SMC IP address interface or SMC VRRP
interface as its default gateway.
The IP address interface naming conventions are as follows:
•
ip1: Real IP Address of first host in a cluster
May 2006
Advertisement
Table of Contents
