2) Exchange
a) Match the setting of new main PCB switches (JSW1, SW3-7) with former main PCB. (Refer to Fig.4)
b) Tum over the separator of new heat conduction sheet and paste the heat conduction sheet on the aluminum
block. (Refer to Fig.5)
c) Install the attached hamess clip on the new main PCB as shown in Fig.6.
3) Installation
a) Install the new main PCB on the control and tighten the screw as shown in Fig.7.
b) Reconnect the connectors, faston terminals and round terminals to the main PCB as before. (Refer to Fig.2)
(Confirm that the connectors are not half inserted.)
43
-
-
'22 • PAC-SM-422