Mitsubishi Heavy Industries SRK100VNXWZRF Service Manual page 124

Error code
Remote control: E47
1. Applicable model
Model FDC100VNP-W
2. Error detection method
Error is displayed if the
converter voltage exceeds target
voltage (3 times within 20
minutes). Remote control may
be set after 3-minute delay.
Error is displayed if the
converter voltage is lower
than 210V (1-time within
5 seconds after power ON)
3. Condition of Error displayed
Same as above
4. Presumable cause
• Defective outdoor unit PCB
• Dust on outdoor unit PCB
• Anomalous power source
Note:
RUN light TIMER light Content
Indoor
5-time
display
ON
flash
5. Troubleshooting
Diagnosis
Is the power source normal?
YES
Is voltage
within the specified range?
YES
Check
soldered surfaces on the
outdoor unit PCB for foreign matter
like dust, fouling,
etc.
φ φ
123
-
Active filter voltage error
(Model FDC100VNP-W only)
NO
NO
NO
YES
-
'22 • PAC-SM-422
Countermeasure
Restore normal condition.
Restore normal condition.
Remove foreign matter like
dust, fouling, etc.
Defective outdoor unit
PCB➞Replace.