Mounting And Dismounting; Safety Messages On Personal Injury; Use In Hazardous Locations Only In Scope Of The Ul Standards; Danger Of Unsafe System Operation - hilscher netBRICK NB 100 User Manual

Table of Contents

Mounting and Dismounting

5 Mounting and Dismounting

5.1

5.1.1

5.1.2

netBRICK NB 100 | Gateway Devices

Obey to the following safety messages on personal injury, when mounting,

dismounting or replacing the netBRICK NB 100 device.

The Use in Hazardous Locations with Potentially Explosive Atmosphere is

only allowed in Scope of the UL Standards!

Important! Outside the scope of the UL standards you are allowed to use

the netBRICK NB 100 device in non-hazardous locations only!

When using the device in hazardous locations with potentially explosive

atmosphere according to UL (UL-Report/File E326833) you must observe

the following safety messages.

Explosion Hazard!

! Do not connect or disconnect the netBRICK NB 100 device unless

power has been removed or the area is known to be non-hazardous.

! Substitution of components may impair suitability for NEC500 Class I,

Division 2, Groups A, B, C, and D.

! Do not use the diagnostic interface DIAG (USB connector) of the net-

BRICK NB 100 device in hazardous locations. Use the diagnostic inter-

face DIAG only, if power has been removed or the area is known to be

non-hazardous.

! Use only a power supply specified according to the UL standard.

Danger of unsafe System Operation

To prevent harm of persons and property damage, do not remove this de-

vice under runtime conditions before you can not guarantee further a safe

and secure operation of the plant.

48/135

Table of Contents