Led Powerlink Controlle Node/Slave - hilscher netBRICK NB 100 User Manual

LEDs
10.3.6

LED POWERLINK Controlle Node/Slave

LED
BS
Number in
the device
drawing:
COM0
BE
Number in
the device
drawing:
COM1
L/A/RJ45
Ch0 & Ch1
&
RJ45
Ch0 & Ch1
&
netBRICK NB 100 | Gateway Devices
DOC091111UM07EN | Revision 7 | English | 2012-02 | Released | Public
The subsequent table describes the meaning of the LEDs for the Real-Time
Ethernet device when the firmware of the Powerlink Controlled Node/Slave
protocol is loaded to the device.
Color State
Duo LED red/green
Off
(off)
Flickering
(green)
Single
Flash
Double
Flash
Triple Flash
On
Blinking
Duo LED red/green
Off
(off)
On
(red)
LED green
On
(green)
Flashing
(green)
Off
(off)
LED yellow
- -
Table 53: LEDs Powerlink Controlled Node/Slave
Meaning
Slave initializing
Slave is in Basic Ethernet state
Slave is in Pre-Operational 1
Slave is in Pre-Operational 2
Slave is in ReadyToOperate
Slave is Operational
Slave is Stopped
Slave has no error
Slave has detected an error
Link: A connection to the Ethernet exists
Activity: The device sends/receives Ethernet frames
The device has no connection to the Ethernet
This LED is not used.
79/135
© Hilscher, 2009-2012