Privilege Setting - Barco CVM 2037 Instruction Manual

PRIVILEGE SETTING

The Privilage Setting menu allows the control of passwords.
It makes them visible and permits modification.
On the menu below are shown the factory set passwords. They
can have been modified to others in your monitor afterwards.
To get into this menu, the highest password (password 4) must be
entered first.
To do so, press ENTER 0 , then enter "password 4" and finally
press ENTER.
Or, starting from normal picture :
ENTER C ie 0
J
Once a password is entered, it remains active within about 10 min-
utes after the last keypress in a menu status.
Passwords have to be re-entered after turn-on of the monitor.
PRIVILEGE SETTING
Password 1
Password 2
Password 3
Password 4
To return without saving :
To return with saving
Once in the menu, press UP or DOWN to move the red field.
EnternewpasswotIsusingthenumerickeysOto9.
Press TOGL to switch between DISABLED and ENABLED .
Press CLEAR to return without saving.
Press ENTER to return with saving.
Available keys and functions if all passwords are enabled :
No password entered VOL CAL PRE
Password 1 entered : all keys and functions except MENU
Password 2 entered : all keys and functions except sub-menus
Password 3 entered : all keys and functions except sub-menu :
Password 4 entered : all keys and functions
37
CD
ENTER
DISABLED
33211
DISABLED
85842
00418 ENABLED
ENABLED
30106
CLEAR
ENTER
INP1 INP2 INP3
COMP INP
0 PRIVILEGE SETTING
6 ALIGNMENT
9 GEOMETRY
0 PRIVILEGE SETTING