Status (Preset Input X) - Barco CVM 2037 Instruction Manual

STATUS (PRESET INPUT X)

STATUS (PRESET INPUT 1)
Contrast
Brightness
Saturation
Hue
Volume
Color
Aperture
Comb
NTSC setup elim.
Size
Sync Source
Sync Time Ct
Scan Delay
Color Temp.
RGB Drive
To return without saving :
To return with saving
Via this menu, you can program the Preset of an input.
When this menu comes up, it shows the actual status of the moni-
tor, not the preset values. This status can be stored as preset for
the selected input, or you can first modify it and then store.
Press UP or DOWN to move the red field.
Press TOGL to modify data in the red field.
Press CLEAR to return without saving.
Press ENTER to return with saving.
Contrast Brightness Saturation Hue : 050
Volume :
Color :
Aperture :
NTSC setup elim.:NO / YES
Size :
Sync Source :
Sync Time Ct : SLOW / FAST
: NORMAL / H-DELAY / V-DELAY / HIV DELAY
Scan Delay
Color Temp. :
RGB Drive :
The monitor holds the parameters set for preset till they are modified
again.
Note also that when you leave this menu and return to normal picture,
when you want to see the monitor in its preset state, you have to
press first.
PRE
22
100
100
100
100
050
ON
OFF
OFF
NO
UNDERSCAN
INTERNAL
SLOW
NORMAL
6500 K
RGB
CLEAR
ENTER
and to
000 050
ON, OFF/FILTER, OFF/FULLBW
OFF / ON
UNDERSCAN / OVERSCAN
INTERNAL / EXTERNAL
6500 K / 3200 K / 9300 K / A / B
RGB / RED only / GREEN only / BLUE only /
RED off / GREEN off / BLUE off
to 200
200