Front Panel Indicators - Barco CVM 2037 Instruction Manual

TALLY LIGHTS
Two tally lights, a red one on the left and a green one on the right.
The tally lights are controlled via the 9-pin connector named
TALLY on the rear side of the CVM.
COMP INP (ANALOG COMPONENTor DIGITAL INPUT)
Green
selected.
SYNC (INTERNAL / EXTERNAL SYNC)
Green
lected.
SL/F (SLOW / FAST)
Green
selected.
INP1, INP2, INP3 (INPUT 1, INPUT 2, INPUT 3)
Green
selected.
GEO (GEOMETRY OVERLAY)
Red
GEO
OVERLAY
COL (COLOUR OVERLAY)
Red
COL
temperature alignment in manual mode or automatic mode (with an
optional Light Probe).
MONO
Green
COMB
Green
The comb filter can only be selected if a
the monitor.
APT (APERTURE CORRECTION)
Green
KEY
Green
(which does not mean that the action is carried out). This LED is lit
also in "Function Mode".
LIM
This red
limit is reached during control via the keyboard, e.g. during con-
trast, brightness and saturation setting

FRONT PANEL INDICATORS

which lights up when the component (Optional) input is
LED
which lights up when external synchronization is se-
LED
which lights up when the fast sync time constant is
LED
which light up when the respective input has been
LEDS
which lights up when the keyboard is set to
LED
for geometry alignment.
which lights up whenever the monitor is set for colour
LED
which lights up when no colour is displayed.
LED
which lights up when the comb filter is selected.
LED
which lights up when aperture correction is enabled
LED
which lights up when a key is pressed and accepted
LED
lights up whenever the upper or lower control range
LED
GEOMETRY
decoder is present in
NTSC
.
9