Failover Mode; Osd Setting; Osd Horizontal Position; Osd Vertical Position - Barco MDSC-2242 User Manual

Hide thumbs Also See for MDSC-2242:
Table of Contents

Advertisement

To select the language
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration menu.
3.
Enter the Language submenu.
4.
Select one of the available languages and confirm.

5.4.3 Failover mode

About failover mode
This function allows the automatic switch to a defined Backup source when the Main input signal is missing.
The display will automatically restore the Main input as soon as the signal is back.
The Backup source is the input selected as "2nd Picture Source" with "2nd Picture Mode" = "Off".
This Main & Backup combination is stored at the moment the function "Failover mode" is set to "Enabled".
Failover Mode is not selectable when either the Main Source or the 2nd Picture Source is set to "Autosearch".
Failover mode is automatically disabled when either the Main Source or the 2nd Picture Source is
changed. A warning message "Failover off" appears on the screen for a few seconds.
Returning to the original Main & Backup combination will automatically re-enable the Failover
feature.
For the MNA version only, Failover mode will be activated up to 12 seconds after the Nexxis signal
becomes unavailable (delay required to allow a Nexxis layout change).
To enable/disable failover mode
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration menu.
3.
Enter the Failover mode submenu.
4.
Enable/Disable failover mode as desired and confirm.

5.4.4 OSD setting

5.4.4.1 OSD Horizontal Position

To adjust the OSD horizontal position
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration menu.
3.
Enter the OSD setting submenu.
4.
Select OSD Hor. Pos.
The command bar OSD Hor. Pos. is highlighted.
5.
Set the OSD horizontal position as desired and confirm.

5.4.4.2 OSD Vertical Position

To adjust the OSD vertical position
1.
Bring up the OSD main menu.
2.
Navigate to the Configuration menu.
3.
Enter the OSD setting submenu.
4.
Select OSD Ver. Pos.
The command bar OSD Ver. Pos. is highlighted.
5.
Set the OSD vertical position as desired and confirm.
Advanced operation
K5903030 (451920611336) /05
MDSC-2242
43

Advertisement

Table of Contents
loading

Table of Contents