Control Function Keys - Barco CVM 2037 Instruction Manual

037
CVM 051
.
-
,
SAT 7
CON 7 BRI 7
1 2 3
)
le
le
l
f
CON \ BRI \ SAT \
4 5 6
.. .
HUE I VOL 7
7 8
HUE \
VOL \
9 0

CONTROL FUNCTION KEYS

There are five pairs of control function keys available: for contrast
brightness, saturation, hue and volume adjustment.
The controls are monitor related and not input related.
Except for the VOL keys, all the control function keys provide the
possibility to act on picture contents.
Pressing such a key causes a direct increase or decrease of the
corresponding actual value. Contininous pressing causes a fast
increase or decrease (after 5 single steps).
The control value is made visible by means of a horizontal format
bar. This format bar disappears automatically from the screen
about 30 seconds after the last key-press or when you press
The LIM LED lights up whenever the upper or lower control range
limit is reached during control via the keyboard.
If you press CAL or during control, the monitor is set to cali-
PRE
brated or preset value for all controls. Refer to the description of
the CAL and command keys.
PRE
CON (CONTRAST UP & CONTRAST DOWN)
Two keys for contrast adjustment.
Keys also used for numeric data entry (1 and 4).
BRI (BRIGHTNESS UP & BRIGHTNESS DOWN)
Two keys for brightness adjustment.
Keys also used for numeric data entry (2 and 5).
SAT (SATURATION UP & SATURATION DOWN)
Two keys for saturation adjustment.
Keys also used for numeric data entry (3 and 6).
HUE (HUE UP & HUE DOWN)
Two keys for hue adjusment. Only useful! when a NTSC decoder is
present in the monitor.
Keys also used for numeric data entry (7 and 9).
VOL (VOLUME UP AND VOLUME DOWN)
Two keys for volume adjustment.
Keys also used for numeric data entry (8 and 0).
NOTE
Keys may be protected and only available after input of a
suitable password. For howto modifythis, refer to the
section on PRIVILEGE SETTING in this manual.
When the keyboard is disabled, following keys are available:
VOL CAL PRE OPT INP1 INP2 INP3 DEG
1 0
CLEAR.