Remote Control - Barco CVM 2037 Instruction Manual

REMOTE CONTROL

I
REMOTE CONTROL
Monitor Address
Address Range : 1 to 48
To return without saving :
To return with saving
The Remote Control menu permits you to determine how the
monitor will respond when connected via its REMOTE1 and
REMOTE2 connectors to a remote control system. Such a remote
control can be a SRC(l) or a MMRC(2).
Use the numeric keys 0 to 9 to set the individual monitor address
between 01 and 48. When set for LISTEN (see below), the
monitor will only listen to these instructions addressed to monitors
with this address.
Use the TOGL key to select between :
: the monitor listens to remote control.
LISTEN
NOLISTEN : the monitor does not listen to remote control
(also not to the SRC).
: combined with 48 address setting to connect
BVRS
the monitor to a BVRS (3) router network. Refer
to the BVRS User Instructions.
Press CLEAR to return without saving.
Press ENTER to return with saving.
Single Remote Control, a BARCO remote controller
(I) SRC
for one CVM2000, CVS, CVM(A) or AVM. More
monitors can be controlled if they are connected in
series, but not individually.
(2) MMRC Multi Monitor Remote Controller, a BARCO full remote
controller for up to 48 BARCO monitors as CVM2000,
CVS, CVM(A) or AVM, all individually or at the same
time
(3) BVRS Barco Video Routing Switcher.
-
01 LISTEN 1
CLEAR
ENTER