Installing Fabric Modules; Installing A Fabric Module - H3C CR19000-16 Installation, Quick Start

Core router

Hide thumbs Also See for CR19000-16:

Table of Contents

Installing fabric modules

CAUTION:

• If you are not to install a fabric module in a fabric module slot, keep the filler panel in the slot.

• The router does not allow a mixture of different models of fabric modules.

• When you install a fabric module, avoid touching the connectors on it.

The router provides six vertical fabric module slots at the rear and comes with all the fabric module

slots empty.

The router supports N+1 fabric module redundancy. You can install two to six fabric modules for the

router.

To install a fabric module:

Place the fabric module on a workbench and remove the protection box from the connector

side of the fabric module.

Figure 9-1 Removing the protection box

Press the spring clip for each ejector lever of the fabric module to release the ejector levers.

Orient the fabric module with the "Up" sign facing up. Align the fabric module with the target

slot and then insert it into the slot along the guide rails.

Continue to push the fabric module until the brakes on its ejector levers touch the slot edges

tightly. Simultaneously close the two ejector levers until the spring clips lock the ejector levers

in place.

9-1

Table of Contents