Installing An Interface Module That Uses General Ejector Levers - H3C CR19000-16 Installation, Quick Start

Figure 7-6 Installing an ejector lever
7. Open the ejector levers and continue to push the module by its middle part on the front panel
until you cannot push it any further.
8. As shown in
panel. Use a Phillips screwdriver to fasten the captive screws on the interface module.
Figure 7-7 Closing an ejector lever
9. As shown in
ejector levers. Place the ejector lever back on their holders and keep them secure for future
use.
Figure 7-8 Removing an ejector lever
Installing an interface module that uses general ejector
levers
1. Wear an ESD wrist strap. Make sure the wrist strap makes good skin contact and is reliably
grounded.
2. Remove the filler panel from the target interface module slot.
Keep the removed filler panel secure for future use.
3. Open the ejector levers of the module. Gently push the module into the slot along the guide
rails.
Figure 7-7, close the ejector levers until they come in close contact with the front
2
1
Figure 7-8, press the spring tab on each ejector lever retainer to remove the
7-5