Table of Contents
Advertisement
2.
Pressing the red part of the handle, pull the fan tray slowly out of the slot along the guide rails.
See Figure2-24.
3.
Put the removed fan tray in an antistatic bag.
Figure2-24 Removing a FAN-40B-1-C fan tray
Installing/removing power modules
WARNING!
• To avoid bodily injury and device damage, strictly follow the procedures in
Figure2-26
• Provide a separate circuit breaker for each power module.
The S6850-56HF-CP switch comes with one power module slot empty and one installed with a filler
panel. You can install power modules for the switch as required. For the available power modules
and their specifications, see H3C S6850-56HF-CP Cold Plate-Based Liquid-Cooled Switch
Hardware Information and Specifications.
Figure2-25 Installation procedure
Install the power
module
Figure2-26 Removal procedure
Switch off the circuit
breaker
Safety guidelines
To prevent device damage and even bodily injury, follow these restrictions and guidelines when you
install or remove a power module:
•
Always wear an ESD wrist strap and make sure the strap makes good skin contact.
•
Before installing a power module, make sure the voltage of the power source is as required by
the power module, and the output voltage of the power module is as required by the device.
•
Do not touch any bare cables or terminals on the power module.
to install and remove a power module.
Connect the power
Disconnect the power
cord
cord
2-15
Figure2-25
Switch on the circuit
breaker
Remove the power
module
and
Advertisement
Table of Contents
