Installing A Filler Panel In A Fabric Module Slot - H3C CR19000-16 Installation, Quick Start
Core router
Hide thumbs
Also See for CR19000-16:
- Installation manual (146 pages) ,
- Preparing for installation (15 pages) ,
- Installation manual (102 pages)
Table of Contents
Advertisement
Figure 9-2 Installing a fabric module
Installing a filler panel in a fabric module slot
1.
Loosen the captive screws on the ejector levers of the filler panel and then open the ejector
levers.
2.
Align the filler panel with the fabric module slot. Push the filler panel slowly into the slot along
the guide rails.
3.
Continue to push the filler panel until the brakes on its ejector levers touch the slot edges
tightly. Then simultaneously close the ejector levers.
4.
Fasten the captive screws on the ejector levers.
9-2
Advertisement
Table of Contents
