Figure2-14 Mounting the switch in the tank (2)
Installing/removing power modules
WARNING!
• To avoid bodily injury and device damage, strictly follow the procedures in
Figure2-16
• Provide a separate circuit breaker for each power module.
The switch comes with two power module slots each installed with a power module. You can replace
a power module as required.
Figure2-15 Installation procedure
Install the power
module
Figure2-16 Removal procedure
Switch off the circuit
breaker
Safety guidelines
To prevent device damage and even bodily injury, follow these restrictions and guidelines when you
install or remove a power module:
•
Always wear an ESD wrist strap and make sure the strap makes good skin contact.
to install and remove a power module.
Connect the power
Disconnect the power
cord
cord
2-9
Figure2-15
Switch on the circuit
breaker
Remove the power
module
and