Table of Contents
Advertisement
4
Defibrillation
4.8
ARGUS LifePoint
Page 46
4.8.2
Setup of the sensor
Only use the securing pads up to their expiration date.
Do not reuse the pads.
1. Connect the LifePoint USB cable to the USB connector.
2. Switch on the device.
3.
Attach the adhesive securing pad on the patient's chest and peel off the foil.
4.
Place the LifePoint on the patient chest and start CPR.
5.
Place your hand on the sensor so that the heel of your hand (1) is in the middle
of the sensor.
6.
Start with CPR and monitor the compression quality on the device and follow the
instructions given by the device (see page before).
7.
The displayed measurements in the middle of the screen informs you about your
CPR quality.
CPR OK
8.
After finishing the intervention, see
1
Depth
5.0
Rate
101
/min
4.7 Finishing the
®
FRED
easyport
CPR
cm
00:59
therapy.
®
plus
Advertisement
Table of Contents
