Opening The Vpn Router 4600 - Nortel Contivity 2600 Install Manual

130 Chapter 8 Nortel VPN Router 4600 option installation

Opening the VPN Router 4600

To replace power supplies and hard disk drives, or to access the diskette drive for
system recovery operations, you must remove the front bezel from the VPN
Router 4600.
The first several times that you remove the front bezel, the bezel can stick because
the ball studs and socket clips are new.
Remove the VPN Router 4600 front bezel as follows:
1
2
3
NN46110-317 02.01
Note: Removing the front bezel on the VPN Router 4600 activates the
chassis intrusion alarm on power only. This intrusion is reported to the
system log file.
Insert a flat-head screwdriver into the slots on the lower left and right sides of
the chassis, and pry the bezel forward.
Slide your fingers between the front bezel and the gateway.
Pull the bezel forward firmly, separating the ball studs on the bezel from the
sockets on the chassis.
Figure 46 on page 131
Router 4600. You do not need to turn off the gateway to remove the front
bezel when installing a power supply or hard disk drive.
shows how to remove the front bezel from the VPN