Figure 53 Removing The Front Bezel - Nortel Contivity 2600 Install Manual

148 Chapter 9 Nortel VPN Router 5000 option installation

Figure 53 Removing the front bezel

3
If the VPN Router 5000 is in an equipment rack, you must remove it from the rack
to add or replace DIMMs, option cards, or fan trays.
To remove the chassis from the rack:
1
NN46110-317 02.01
Grip the two handles, and firmly pull the bezel toward you to unsnap it from
the chassis.
The first several times that you remove the front bezel, the bezel can stick
because the ball studs and socket clips are new.
Note: If you are replacing a hard disk drive, you do not need to remove
the chassis from the equipment rack; go to
on page 168.
At the front of the chassis, remove the two 1/2-in. truss screws that secure the
bottom of the chassis to the equipment rack.
Warning: Risk of injury
The VPN Router 5000 weighs approximately 50 pounds (23 kg). This
weight is not evenly distributed; the right side of the gateway weighs
more than the left. Therefore, two people must remove the system from
the equipment rack.
CS260015C
"Replacing a hard disk drive"