Identifying Remote Connectivity Problems; Displaying Messages From The Router Console; Displaying Statistics And Error Messages - Nortel Remote Access for AN and Passport ARN Routers Configuration Manual

Configuring remote access for an and passport arn routers
Table of Contents

Advertisement

Configuring Remote Access for AN and Passport ARN Routers

Identifying Remote Connectivity Problems

The sections that follow provide guidelines for isolating a router addressing
problem or a netboot problem. Proceed to the appropriate section:

Displaying Messages from the Router Console

Displaying Statistics and Error Messages

Guidelines for Using Packet Capture
Guidelines for Using a LAN Protocol Analyzer
Displaying Messages from the Router Console
If you cannot connect to the AN/ANH or ARN router using Site Manager, Nortel
Networks recommends that you use a modem or terminal console to connect to
the router using the Technician Interface.
If you cable a modem to the AN/ANH or ARN router, you can dial in and connect
to the router remotely. This setup provides the same capabilities as an on-site
console connection. Modem communications, however, are slower.
Viewing an AN/ANH or ARN router error message and entering commands using
a modem connection may simplify troubleshooting if you are not at the router site.
As an alternative, you can ask the person at the router site to read the console
messages to you and then you can tell that person which commands to enter.
Displaying Statistics and Error Messages
Use the Statistics Manager Quick Get tool or the Technician Interface
command to display the number of BootP and TFTP packets forwarded and
dropped for each interface in the path between the AN/ANH or ARN router and
the BootP server.
Use the Events Manager or the Technician Interface
events associated with the interface and the BootP and TFTP protocols.
For instructions on using the Quick Get tool and the Events Manager, see
Configuring and Managing Routers with Site Manager. For a description of events
that appear in the log, see Event Messages for Routers. For instructions on using
the
get
B-8
and
log
commands, see Using Technician Interface Software.
(page
B-8)
(page
B-8)
(page
B-9)
(page
B-9)
command to display the
log
get
308614-14.20 Rev 00

Advertisement

Table of Contents
loading

This manual is also suitable for:

An seriesAnh seriesArn series

Table of Contents