Table of Contents
Advertisement
3
Safety instructions
3.1
Representation of hazards,
cautions and notes
3.2
Personnel
3.3
Responsibility and guarantee
IMT Analytics AG
This User Manual uses the representation below to specifically draw attention to
residual risks during intended use and emphasize important technical requirements.
Information and/or instructions and prohibitions to prevent damage of
any kind.
Work on and with FlowMeter may only be performed by persons who
have undergone appropriate general technical training and have the
necessary experience.
The manufacturer accepts no responsibility or guarantee and will be exempt from li-
ability claims accordingly if the operator or any third parties:
• fail to use the device in accordance with its intended use
• disregard the specifications
• tamper with the device in any way (conversions, modifications, etc.)
• operate the device with accessories that are not listed in the associated sets
of product documentation
• Report any serious incident that has occurred in relation to the
medical device to the manufacturer
and the authority having jurisdiction in their locale
• The device has user replaceable parts
and servicing
• Neligence of warning and error messages can lead to damage of
the device
• The device including the measurement channel shall not be ex-
posed to high level of volatile organic compounds (VOC). Doing
so may lead to permanent offset of the humidity sensor.
• Only use original packaging in good condition for transport or
storage
• The device must not be placed in a pressure chamber
• The device is not intended to measure flammable or combustible
gases
• The device is not intended to measure liquids
• The device must not be connected to a telecom network
• The device must only be connect to approved equipment with
CE, CSA, UL or other equivalent safety mark to ensure double
insulation
(8.6.2 Technical
(8.3 Preventive cleaning
routines)
Safety instructions
3
support)
7
Advertisement
Table of Contents
Need help?
Do you have a question about the FlowMeter F1 and is the answer not in the manual?
Questions and answers