Coffee Dose Programming - LAVAZZA blue CLASSY CUSTOM MILK LB1050 Instructions Manual

EN

COFFEE DOSE PROGRAMMING

It is NOT possible to program the coffee
dose in milk-based beverages.
The amount of supplied coffee can be changed
by carrying out the operations below.
Press the ON/STAND-BY
machine on.
The machine will be ready when the ON/
STAND-BY
button tstops blinking and the
coffee supply buttons lights
are steadily.
Place the mug/cup as shown in chapter
ARATION FOR COFFEE
Lift the loading lever until it locks into position
to open the capsule fitting compartment.
Put a Lavazza
compartment.
Lower the capsule loading lever.
Press down the button of the icon you wish to
program.
Keep the programming button pressed
down.
Do not press any other button; any opera-
tion carried out on the other buttons will be
ignored.
50
PROGRAMMING
to switch the
PREP-
SUPPLY.
capsule into the fitting
The machine will start supplying and, after
approximately 5 seconds, the other coffee
buttons will start blinking and the machine will
beep to indicate that the programming
mode has been accessed.
Once the desired amount of coffee has been
obtained, stop supply by releasing the button.
The machine will emit a beeping sound
and will stop, and the dose will be programmed.
If the programmed measure exceeds the
maximum allowed the machine will
automatically stop delivery, the delivery button
will blink and the last programmed measure will
be saved in the memory.
If there is a power failure during programming,
the last programmed value remains in the
memory.
If during a dose programming, water lack
indicated, the machine stops the supply and the
dose being programmed won't be saved.
Once filled the water tank, repeat the dose
programming procedure.
,
is