LAVAZZA blue CLASSY CUSTOM MILK LB1050 Instructions Manual page 44

EN
Press the button ON/STAND-BY
to switch the machine on.
The machine will emit an acoustic signal
All buttons will come on to a steady white light,
whereas the alarm warning lamps will come on
to a steady orange light over an instant.
When the milk frothing jug is not inserted,
the machine will only turn the coffee supply-
ing buttons
perature Boost button with a low light.
The milk beverage warning lights will be
OFF and the buttons will not work.
The machine will be ready when the ON/
STAND-BY
are steadily.
44
PREPARING THE MACHINE
and the Tem-
button stops blinking and the
coffee supply button lights
CLEANING ON THE FIRST MACHINE
START
Upon the first machine start-up, you shall sup-
ply (16 fl oz/0.5 litres) of water, with no capsule
inserted and keeping the lever lowered.
Place a cup under the supply spout
Press the FREE DOSE beverage
to start supplying.
.
When the container is full, press the button
again to end the supply.
Open and close the lever before removing
and emptying the cup.
Empty the cup and supply one more time, by
pressing the FREE DOSE beverage
ton again.
When a supply is selected, the machine will
activate the electric water pump over 10
seconds.
If water is found inside the hydraulic circuit,
the machine will normally supply.
If no water is found inside the hydraulic cir-
cuit, the machine will stop supplying over 5
seconds and will try to supply again up to a
maximum of 5 time.
After 5 attempts have been made, the ma-
chine will cause the "No water"
lamp to come on to a steady
to inform that water is missing, and will also
emit an acoustic signal
button
but-
warning
orange light,
.