Coffee Dose Programming - LAVAZZA BLUE LB 1100 Instructions Manual

EN
An acoustic signal and the turn-off of the red signal
light indicate the correct locking of the arm.
If the arm is lowered without the capsule being
inserted, by pressing one of the coffee brewing but-
tons three acoustic signals are emitted.
Make sure the machine is ready for brewing:
4
brewing buttons are lit continuously. Press the
manual coffee dose brewing button to start
brewing. Once the desired amount of brewed
coffee is reached, press the button again to stop
brewing.
During coffee brewing, the pressed button flashes.
After the brewing, the same button remains lit and
flashing and then continuously lit, indicating the
machine is ready.

COFFEE DOSE PROGRAMMING

The programming of the dose is done by using the
same button. Pressing any other button shall be ig-
nored. The programmed amount of brewed coffee
(minimum 20 cc) can be changed by repeating the
programming. If a dose inferior to 20 cc is set, the
machine memorizes however 20 cc.
Perform steps 1, 2, 3 of paragraph MANUAL
COFFEE DOSE BREWING.
Press and hold one of the two coffee brewing
4
buttons for at least 3 seconds. The selected but-
ton and the green signal light flash; the machine
emits three sounds indicating the start of pro-
gramming. At this point, release the button.
Once the desired coffee amount is reached, stop
5
the brewing by pressing the button again. The
machine emits three sounds indicating the suc-
cessful new programming.
18
COFFEE BREWING
COFFEE BREWING
If the programming does not occur in maximum
1'50", the machine automatically stops brewing,
the brewing button flashes and the dose of the last
programmed value remains in the memory. If there
is a power failure during programming, the last
programmed value remains in the memory.
PROGRAMMED COFFEE DOSE BREWING
Perform steps 1, 2, 3 of paragraph MANUAL
COFFEE DOSE BREWING.
Press one of the two coffee brewing buttons
4
(if programmed). The machine stops brewing
automatically once the preset coffee dose is
reached.
If there are anomalies during coffee brewing with
preset dose, the machine continues brewing in
manual coffee dose mode. The brewing can be
stopped by pressing the button again.
REMOVING USED CAPSULES
An alternative flash of the coffee brewing, hot
water dispensing and steam dispensing but-
tons, anomaly signal light and an acoustic signal
indicate that the used capsule drawer is full and
needs to be emptied and reinserted.
E N
15