Table of Contents
Advertisement
Place the seat/bunk combination into the
#
front seat anchorages
front and allow to engage.
Make sure that release handles for front seat
#
legs
2
are folded underneath in the direc‐
tion of the floor of the vehicle.
Fold the seat/bunk combination back into
#
the seat position.
Press the release handle for the rear seat
#
anchorage
1
downwards until the indicator
tabs
4
have fully retracted into the rear seat
anchorages.
The rear seat anchorages of the seat/bunk com‐
bination are correctly engaged when the seat
anchorages engage audibly and the indicator tabs
4
on the seat anchorages are no longer visible
and have fully retracted into the seat anchorages.
Head restraints
Adjusting the head restraint manually
& WARNING Risk of injury when adjusting
vehicle settings while the vehicle is in
motion
You could lose control of the vehicle in the
following situations:
if you adjust the driver's seat, the head
R
restraints, the steering wheel or the mir‐
ror while the vehicle is in motion
if you fasten your seat belt while the vehi‐
R
cle is in motion
Before starting the vehicle's drive sys‐
#
tem: adjust the driver's seat, the head
restraints, the steering wheel or the mir‐
ror and fasten your seat belt.
& WARNING Risk of injury due to head
restraints not being fitted or being adjus‐
ted incorrectly
If head restraints have not been installed or
have not been adjusted correctly, there is an
increased risk of injury in the head and neck
area, e.g. in the event of an accident or when
braking.
Always drive with the head restraints fit‐
#
ted.
Before driving off, make sure for every
#
vehicle occupant that the centre of the
3
from above at the
head restraint supports the back of the
head at about eye level.
Using the head restraint fore-and-aft adjustment,
adjust the head restraint so that it is as close to
the back of the head as possible.
To raise: pull the head restraint upwards into
#
the required position and secure once the
head restraint is engaged in the desired posi‐
tion.
Use the head restraint only in the engaged
state.
To lower: push release button
#
the head restraint downwards into the
required position and ensure that the head
restraint is engaged in the desired position.
Use the head restraint only in the engaged
state.
To move forwards: push release button
#
and pull the head restraint forwards until it
engages in the required position.
To move backwards: push release button
#
and slide the head restraint backwards into
the required position.
To remove: press release knob
#
the head restraint up and out.
To fit: press the head restraint with detent
#
into the holes on the left-hand side when
viewed in the direction of travel until it
engages.
Seats and stowage
1
and slide
2
1
and pull
91
2
Advertisement
Table of Contents
