Table of Contents
Advertisement
Turn headlamp range adjuster
#
required position.
If the vehicle is unladen, select position g.
#
The illumination of the road should be 40 m to
100 m and low beam must not dazzle oncoming
traffic.
You can use the headlamp range adjuster to
adjust the light cone of the headlamps to your
vehicle's load condition. The light cone will
change as the seats are occupied or the load
compartment is loaded or unloaded. This can
cause visibility conditions to deteriorate and you
could dazzle oncoming traffic.
Operating the combination light switch
1
High beam
2
Right turn signal light
3
Headlamp flashing
4
Left turn signal light
Use the combination switch to activate the
#
desired function.
Switching on high beam
Switch on the low beam (
#
Push the combination switch forwards 1.
#
The K indicator lamp on the instrument
cluster will light up.
%
The high beam switches to the à position
only in darkness and when the drive system
has been switched on.
Headlamp flashing
Briefly pull the combination switch in the
#
direction of arrow 3.
1
to the
page 102).
/
Turn signal lights
To indicate: push the combination switch in
#
the required direction
engages. In the case of larger steering move‐
ments, the combination switch will automati‐
cally switch back.
To indicate briefly: tap the combination
#
switch briefly in the required direction
4. The corresponding turn signal lamp will
flash three times.
Switching the hazard warning light system
on/off
Press button 1.
#
If you operate a turn signal indicator while the
hazard warning light system is switched on, only
the turn signal lamps on the relevant side of the
vehicle will light up.
The hazard warning light system will switch on
automatically in the following situations:
the airbag is deployed
R
the vehicle is heavily braked from a speed of
R
more than 70 km/h to a standstill.
The hazard warning lights will automatically
switch off when the vehicle regains a speed of
more than 10 km/h after maximum full-stop
braking.
%
The hazard warning light system will work
even when the vehicle has been switched off.
Light and vision 103
2
or
4
until it
2
or
Advertisement
Table of Contents
