HunterDouglas PowerView Gen 3 Automation Manual page 13

Headrail-Mounted Rechargeable Battery Wand
Install the Rechargeable Battery Wand Clips
Hook the clip onto the back channel of the headrail.
■
IMPORTANT: Position the clip so that the battery wand will be between installation
brackets.
Rotate the clip down and press the middle of the clip until it snaps into place.
■
Mount the Rechargeable Battery Mount into the Rechargeable Clips
From the back of the shade headrail, connect the power cable from the motor side into the
■
socket on the rechargeable battery mount.
Align the slots in the battery mount
■
with the battery wand clips.
Push the battery mount onto the
■
battery wand clips until it snaps
into place. Check to make sure
the battery mount is secure.
CAUTION: Be sure the cable does not become pinched by the battery wand clips during
installation. Damage or overheating of components could result.
NOTE: Do not install the rechargeable battery wand into the battery mount before
installing the shade. See "STEP 4: Connect the Power Source" on page 13 for
instructions on inserting the battery wand into the battery mount.
Proceed to "STEP 3: Install the Shade" on page 12.
Rechargeable
Clip
Socket
INSTALLATION
Front of
Headrail
11