HunterDouglas Country Woods Installation And Care Instructions

Wood blinds, 2" movable slat specialty shapes

Advertisement

Quick Links

Installation and
Care Instructions
Country Woods
Wood Blinds
2" Movable Slat
Specialty Shapes
THANK YOU
THANK YOU
THANK YOU
THANK YOU for purchasing a Hunter Douglas product. Your
THANK YOU
new blind has been custom built for you from the highest quality
materials. Once in your window, it will provide you with a lifetime
of beauty and trouble-free use.
Getting Started
• Remove the blind from the package. Keep the packaging until the
blind operates to your satisfaction.
• Check the diagram to make sure you have the necessary parts.
• Contents of your hardware package may vary depending upon
mounting options chosen and whether intermediate brackets are
needed.
®
2" or 4" Extension
Brackets (Optional)
Valance Clips
Corner Clips
(for Valance Returns)

Tools needed for installing your shade.

• Measuring tape
• Pencil
• Flat blade screwdriver
• Phillips screwdriver
In addition, you will need fasteners designed to work with your
specific mounting surfaces:
Mounting Surface
Drywall, Plaster
Metal
Wood
End
Bracket
Hold-Down
Bracket and Pin
(Optional)
• Carpenter's level
• Power drill, drill bits and
bit socket (or socket wrench with
/
1
Wall Anchors, Expansion Bolts
(Not Provided)
Sheet Metal Screws
(Not Provided)
No. 6 Hex Head Screws
(Provided)
Bracket
Intermediate
Bracket
Hold-Down
Bracket and Pin
(Optional)
/
" hex
1
4
" hex socket)
4
Fastener
End
Valance

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Country Woods and is the answer not in the manual?

Questions and answers

Summary of Contents for HunterDouglas Country Woods

  • Page 1 • Check the diagram to make sure you have the necessary parts. • Contents of your hardware package may vary depending upon mounting options chosen and whether intermediate brackets are needed. Country Woods ® 2" or 4" Extension Brackets (Optional)
  • Page 2 7:00 AM to 4:30 PM MST, Mon.-Fri. Mark • Mark where ends of headrail will be located. Visit our Web site at hunterdouglas.com • Either hold headrail up to the mounting surface or measure the headrail and mark its length.
  • Page 3 • If the brackets are flush with the back wall, attach them with one screw through a top hole and one through a rear hole. Complete the Installation • Space intermediate bracket(s) evenly between the end brackets. Attach the Wand (If Ordered) If the blind was ordered with a wand tilter, attach the wand to the metal shaft.
  • Page 4 Make sure the slats are in the cord stop. open position. Raise and lower Like any wood furnishings, Country Woods blinds should be cleaned the blind. on a routine basis to keep them looking new. • Dust regularly. Use a soft clean cloth, chemically-treated dust cloth or dusting mitt.

Table of Contents