Table of Contents
Advertisement
9.7
Installation
Assemble the valve in reverse order of disassembly. Observe the notes and
instructions given in the following sections when doing so.
9.7.1
O-Ring on the valve disk
Carry out the following steps:
1.
–
9.7.2
Fitting the piston
Fig.12:
Carry out the following steps:
1.
®
9.7.3
Fitting position
The valve must be installed in vertically suspended position. This is the only
position in which the valve housing can reliably drain.
430BAL008565EN_1
21.03.2022
Fit the O-ring for the valve disk (7) without applying any grease.
Done.
Fitting the piston
Fit the piston (17) so that the recess points towards the lock washer (27).
Done.
Maintenance
Installation
37
Advertisement
Table of Contents
Need help?
Do you have a question about the VARIVENT TSVN and is the answer not in the manual?
Questions and answers