Devices" Tab - OCULUS ImageCam 3 Instruction Manual

12.5.2

"Devices" Tab

Instruction Manual ImageCam® 3 (G/69200/XXXX/EN 0120 Rev01)
9
8
7
6
5
1 Drop-down list for selecting a database
2 Radio button "load while starting"
3 Folder selection
4 Drop-down list for selecting a device
5 [Write permission] check box
Fig. 12-8: "Devices" tab
"Database" Group Box
Different users can be set up for different databases.

In the drop-down list for selecting a database (1), choose the entry
(User) that you would like to edit.

Choose the corresponding path for the database, data, and images
via the individual buttons for folder selection (3).
Normally, two different folders are created and displayed for data
and image during installation (8).
For data: Name of the device plus the .DAT identifier

For images: Name of the device plus the .BMP identifier


For each user, activate whether the associated database should be
actively switched on or not (9).
In case more than one database is active, an additional drop-down list
appears on the main page of the Patient Data Management user
interface. You can activate a user (or the assigned database) in this list.
The patient list and the associated examinations are updated when the
active user is changed.

You can also activate the option "load while starting" (2) for just one
user. The associated database will then normally be loaded at start
of the Patient Data Management user interface and is pre-selected.
12 Patient Data Management
6 Path for the currently selected device
7 check box for activating a device
8 Path for the database
9 check box for activating a database
1
2
3
4
51 / 68