Solid-State Drive; Removing The M.2 2230 Solid-State Drive - Dell Inspiron 16 7630 Service Manual

Steps
1. Using the alignment posts, place the battery on the palm-rest and keyboard assembly.
2. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
3. Replace the six screws (M2x3.5) that secure the battery to the palm-rest and keyboard assembly.
4. Connect the battery cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in

Solid-state drive

Removing the M.2 2230 solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE: The M.2 card installed will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
● M.2 2230 solid-state drive + M.2 2230 mounting bracket
● M.2 2280 solid-state drive
The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components 21