Steps
1. Disconnect the battery cable from the system board.
2. Remove the six screws (M2x3.5) that secure the battery to the palm-rest and keyboard assembly.
3. Lift the battery off the palm-rest and keyboard assembly.
Installing the 6-cell battery (86 Wh)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
This procedures only applies if you are installing a 6-cell battery (86 Wh) into your computer.
The following image(s) indicate the location of the 6-cell battery (86 Wh) and provides a visual representation of the installation
procedure.
20
Removing and installing components