Table of Contents
Advertisement
14. Connect the display cable to the connector on the system board and close the latch.
15. Adhere the tape that secures the display-cable connector latch to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Heat sink
Removing the heat sink (UMA)
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
NOTE:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
NOTE:
This procedure applies only to computers shipped with an UMA graphics processor.
The following image(s) indicate the location of the heat sink (UMA) and provides a visual representation of the removal
procedure.
Steps
1. In reverse sequential order (4 > 3 > 2 > 1), loosen the four captive screws that secure the heat sink to the system board.
2. Lift the heat sink off the system board.
38
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Hide quick links:
Advertisement
Table of Contents
