Steps
1. Place the heat-sink on the system board.
2. Align the screw holes on the heat sink with the screw holes on the system board.
3. In sequential order (1 > 2 > 3 > 4 > 5 > 6 > 7) tighten the seven captive screws that secure the heat sink to the system
board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Power button
Removing the power button
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
This procedure applies only to computers shipped with a standard power button.
The following image(s) indicate the location of the power button and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
41