NOTE:
The etchings on the system-board shield do not represent the components that are supported by this computer.
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the installation
procedure.
Figure 27. Installing the system-board shield
Steps
1. Align the screw holes on the system-board shield with the slots on the display-assembly base.
2. Place the system-board shield on the display-assembly base.
3. Replace the four screws (M3x5) that secure the system-board shield to the display-assembly base.
Next steps
1. Install the
I/O
cover.
2. Install the
back
cover.
3. Install the stand.
4. Follow the procedure in
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
51