Steps
1. Place the touchpad into its slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the touchpad with the screw holes on the palm-rest and keyboard assembly.
3. Replace the five screws (M2x1.8) and the three screws (M1.6x2.5) that secure the touchpad to the palm-rest and keyboard
assembly.
4. Connect the touchpad cable to the touchpad and close the latch.
5. Connect the touchpad cable to the system board and close the latch.
Next steps
1. Install the
4-cell battery (64 Wh)
2. Install the
base
cover.
3. Follow the procedure in
56
Removing and installing components
or the
6-cell battery (86
After working inside your
Wh), whichever is applicable.
computer.