Table of Contents
Advertisement
8. Connect the touchpad cable to the system board and close the latch.
9. Connect the speaker-board cable to the connector on the system board.
10. Connect the speaker cables to the connector on the system board.
11. Connect the I/O board cable to the connector on the system board and close the latch.
12. Connect the fan cable to the connector on the system board.
Next steps
1. Install the
heat sink (UMA)
2. Install the fan.
3. Install the
display
assembly.
4. Install the
wireless
card.
5. Install the
M.2 2280 solid-state drive
6. Install the
4-cell battery (64 Wh)
7. Install the
base
cover.
8. Follow the procedure in
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
4-cell battery (64 Wh)
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the removal procedure.
54
Removing and installing components
or the
heat sink
(discrete), whichever is applicable.
or the
M.2 2230 solid-state
or the
6-cell battery (86
After working inside your
Before working inside your
or the
6-cell battery (86
drive, whichever is applicable.
Wh), whichever is applicable.
computer.
computer.
Wh), whichever is applicable.
Hide quick links:
Advertisement
Table of Contents
