Integrated Peripherals Setup Menu - DTK PAM-0075I User Manual

Chapter 4
4.7

INTEGRATED PERIPHERALS SETUP MENU

The Integrated Peripherals setup option is need to change the values of the I/O chipset
registers for I/O functions.
IDE HDD Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
On-Chip Primary IDE
On-Chip Secondary IDE
USB Keyboard Support
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
Onboard UART2 Mode
Onboard Parallel Port
Parallel Port Mode
A short description of the screen items follows:
IDE HDD Block Mode: This allows your hard disk controller to use the fast block mode to
transfer data to your hard disk drive.
IDE Primary Master PIO/IDE Primary Slave PIO/IDE Secondary Master PIO/IDE
Secondary Slave PIO: Available selection are "Auto", "Mode 0", "Mode 1", "Mode 2", "Mode 3"
and "Mode 4". To choose "Auto", the system BIOS will scan the IDE device and decide which
mode of the device is . Otherwise the user should key in the mode of the device to the
corresponding field.
Some harddisks cannot work properly with its corresponding timing, please set a slower
timing.
40
ROM PCI/ISA BIOS (2A59ID1G)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
: Disabled ECP Mode Use DMA
: Auto EPP Mode Select
: Auto
: Auto
: Auto
: Auto
: Auto
: Auto
: Auto
: Enabled
: Enabled
: Disabled
: Enabled
: 3F8/IRQ4
: 2F8/IRQ3
: Standard
ESC: Quit
F1: Help
F5: Old Values
: 3BC/IRQ7
F7: Load Setup Defaults
: ECP+EPP
Fig. 26
: 1
: EPP1.9
? ? ? ? ? ? : Select Item
PU/PD/+/-: Modify
(Shift)F2: Color