Integrated Peripherals Setup Menu - DTK PRM-0076I Manual

Chapter 4
4.7

INTEGRATED PERIPHERALS SETUP MENU

The Integrated Peripherals setup option is need to change the values of the I/O chipset
registers for I/O functions.
IDE HDD Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
USB Keyboard Support
Init Display First
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
RxD, TxD Active
IR Transmittion delay
A short description of the screen items follows:
IDE HDD Block Mode: This allows your hard disk controller to use the fast block mode to
transfer data to your hard disk drive.
IDE Primary Master PIO/IDE Primary Slave PIO/IDE Secondary Master PIO/IDE
Secondary Slave PIO: Available selection are "Auto", "Mode 0", "Mode 1", "Mode 2", "Mode
3" and "Mode 4". To choose "Auto", the system BIOS will scan the IDE device and decide
which mode of the device is . Otherwise the user should key in the mode of the device to the
corresponding field.
Some harddisks cannot work properly with its corresponding timing, please set a slower
timing.
32
ROM PCI/ISA BIOS (2A69JD1C)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
: Enabled
: Auto
: Auto
: Auto
: Auto
: Auto
: Auto
: Auto
: Auto
: Enabled
: Enabled
: Disabled
: AGP
: Enabled
: 3F8/IRQ4
: 2F8/IRQ3
: IrDA
: Hi, Lo
: Enabled
Fig. 26
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
ECP Mode Select
ESC: Quit
F1: Help
F5: Old Values
F7: Load Setup Defaults
: 378/IRQ7
: ECP+EPP
: 3
: EPP1.7
↑ ↓ → ←: Select Item
PU/PD/+/-: Modify
(Shift)F2: Color