3.3
JP6 - IrDA IR CONNECTOR
JP6 is a four pin connector, which use the UART2 as interface for IrDA. You must also
configure the setting through "UART2 Mode" in Integrated Peripheral BIOS Setup to
select the UART2 as HPSIR or ASKSIR. The pin definition menu is as following:
3.4
J2 - MULTIPLE FUNCTION JUMPER
J1 is a front panel multi-function jumper include speaker, reset, keylock, Harddisk LED,
ATX power button. The pin definition is as following figure.
The power is turned on by short the power button once. It needs to hold the power
button about 4 seconds to turn it off when it has not start to display.
Fig. 15 IrDA IR Connector
Fig. 16 Multiple Function Jumper
Connector Configuration
25