Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Closer Platform (Option) and
Features (After 02/2022)
The Closer Platform allows the user to mount 5 different
features: Closer Wheel, Flat Bar Basket 20", Closer Disc,
Crumbler Wheel, Packer Reel or Treader.
IMPORTANT
ALWAYS REPLACE PARTS WITH UPDATED
CLOSER PLATFORM.
Figure 3-14: Closer Platform Assembled
with Treader (After 02/2022)
NOTE
When setting up the Ripper to operate at 14" or less
depth, position the Closer Pivot Mount in the lower two
holes of the shank.
When setting up the Ripper to operate at 14" or greater
depth, position the Closer Pivot Mount in the upper two
holes of the shank.
Closer Platform Spring Set Up
Instructions (After02/2022)
Use the Spacers/Bushings on either side of the Slide
Bushing to fine tune the down pressure.
•
To increase the down pressure, place both
spacers between the Rear Spring Keeper and the
Slide Bushing.
•
To decrease the down pressure, place both
spacers between the Retaining Washer and the
Locknuts.
NOTE
The Large Retaining Washer must always be on the back
side of the Slide Bushing.
3-16
TABLE OF CONTENTS
RETAINING WASHER
REAR SPRING KEEPER
Figure 3-15: Closer Platform Spring Setup (After
REAR
CLOSER WHEEL
CLOSER DISC
Figure 3-16: Closer Platform Finishing Options
SPACER/BUSHING
SLIDE BUSHING
SPACER/BUSHING
02/2022)
FLAT BAR BASKET 20"
CRUMBLER WHEEL
TREADER
PACKER WHEEL
LOCKNUTS
1-3/8" TYPICAL
SPACING
& PRELOAD
F-1040-0123
Advertisement
Table of Contents
