Table of Contents
Advertisement
Coverboard Installation
1. Insert four 1/2-13 x 2-1/2 Bolts into the Coverboard
Bracket before attaching the Coverboard Furrower.
(See Figure
3-6.) Secure with 1/2-13 Locknuts and
tighten only so that locking portion of nut engages
the thread. The customer will tighten these nuts after
mounting to shank.
2. Tighten the 7/16-14 Flange Nut to the 7/16-14 x 1-1/4
Plow Bolt before tightening the 1/2-13 Locknut to the
1/2-13 x 1-1/2 Roundhead Bolt. This is to ensure that
the point of the Coverboard Furrower is pulled tightly
against the Bracket. Make sure that the Plow Bolt
Head is flush with the surface of the Coverboard
Furrower.
(See Figure
tightened now.
FLANGED LOCKNUT, 7/16-14
FLANGED LOCKNUT, 1/2-13
LOCKNUT, 1/2-13
COVERBOARD FURROWER
PLOW BOLT, 7/16-14 X 1-1/4
BOLT, 1/2-13 X 1-1/2
Figure 3-8: Coverboard Installation
TABLE OF CONTENTS
3-8.) This hardware should be
BOLT,
1/2-13 X 2-1/2
COVERBOARD BRACKET
ASSEMBLY INSTRUCTIONS
3-9
Advertisement
Table of Contents
