Landoll 2511 IN-3-30 2511 N-4-30 2511 N-5-30 Operator's Manual page 32

ASSEMBLY INSTRUCTIONS
Right Hand & Left Hand Coulter
Assemblies
1. Assemble Coulter Adjustment Tube to Coulter
Assembly using Roll Pins 1/2 x 4 and 5/16 x 4.
Assemble the Coulter Stop to the Coulter Adjustment
Tube using 1/2 x 4 Bolt and Locknut.
Figure 3-4)
2. Install the Coulter Adjustment Tube and Coulter
Assembly to the Frame using the Coulter Clamp
ADJUSTMENT PIN
COULTER
ADJUSTMENT TUBE
COULTER
CLAMP PLATE
BOLT,
1/2-13 X 4
LOCKNUT,
5/8-11
RH ASSEMBLY
EXPANDED VIEW
3-4
TABLE OF CONTENTS
(See
COULTER
CLAMP TUBE
COULTER STOP
LOCKNUT,1/2-13
ROLL PINS
COULTER
ASSEMBLY
SMOOTH BLADE
Figure 3-4: Coulter Assembly
Tube, 4 U-Bolts, Clamp Plate and 5/8-11 Locknuts.
Do not tighten nuts until the depth adjustment is
completed.
3. Use Adjustment Pin and 3/16 Hairpin to set desired
depth. Tighten 5/8 Locknuts on the U-Bolts.
4. Attach Coulter Blade to Coulter Assembly using 1/2 x
1-1/2 Bolts and Locknuts.
HAIRPIN
U-BOLT
RIPPLED BLADE
PYRAMID BLADE
LH ASSEMBLY
F-1040-0123