SMV Bracket Installation
1. Attach the SMV mounting bracket at a point where
emblem is visible from rear of machine, using U-Bolt
and 5/8-11 Flange Head Serrated Nuts
Figure
3-3.)
2. Attach SMV emblem to top of SMV mounting bracket
using 1/4-20 x 1 Hex Head Cap Screws, Flat
Washers, and Locknuts
HYDRAULIC RESET CYLINDER
SMV EMBLEM
SMV BRACKET
COULTER BLADES
TABLE OF CONTENTS
(See
(See Figure
3-11.)
Figure 3-3: 2512 Series Parts Identification
ASSEMBLY INSTRUCTIONS
ID PLATE
JACK STAND, FRONT
HYDRAULIC
ACCUMULATOR
3-3