Create A New Array - Promise Technology SuperTrak SX6000 Procedure

Create a new array

After deleting the array, the interface leaves you at Delete Array. Press
1.
mark Define Array, then press SEL. The RAID definition list appears with RAID
Level marked.
Press SEL at RAID Level. The RAID Level menu appears. Press
2.
the Level of the previous array, then press SEL.
Press SEL at Stripe Block Size. The default size is 64KB. Press
3.
size, if required. With the desired size marked, press SEL.
The Gigabyte Boundary default is ON. To leave it ON, press
4.
Drives. To turn it OFF, press SEL. The mark will move to Add/Remove Drives.
Offline Array Recovery Procedures—SuperTrak SX6000 and UltraTrak, Version 5a
33 of 34
once to
until you come to
to select a smaller
to mark Add/Remove