Table of Contents
Advertisement
Case 4: Array goes
problem.
Do NOT reconnect power to this disk while the system is running.
Turn off the SuperTrak PC or the UltraTrak.
1.
Determine the cause of the power problem and correct it. Carefully check Y-splitter
2.
cables on SuperTrak and disk carrier locks on UltraTrak.
Replace any removed disks in their original order.
3.
Reboot the SuperTrak PC or the UltraTrak. The array will be restored to its previous
4.
status.
If the array goes
steps:
Shut down the system.
a.
Boot (turn on) the SuperTrak PC or the UltraTrak.
b.
Delete the existing array and create a new one.
c.
Warning:
carefully.
Refer to the sections SuperTrak BIOS Recovery Procedure on page 23,
or UltraTrak Recovery Procedure on page 29, for step-by-step
instructions.
Reboot the system. Array status will be
d.
Offline Array Recovery Procedures—SuperTrak SX6000 and UltraTrak, Version 5a
due to a disk power
OFFLINE
Warning
Important
rather showing its previous status, follow these
OFFLINE
This procedure may result in data loss. Follow instructions
20 of 34
.
FUNCTIONAL
Advertisement
Table of Contents
