Table of Contents
Advertisement
Operation and Maintenance Instructions
Automatic Program Start
With this function, the selected program runs immediately after closing the door. If
this function is not available in standard, it must be activated in the settings menu
beforehand.
To activate this function (Fig. 6):
1. Press and hold the Start key (4) with the appliance on and door open until 'AS'
is shown in the display.
2. To deactivate the function, press and hold the Start key (4) again for five
seconds with door open.
Bottom Sieve Removal
1. Rotate the lower wash arm perpendicular to the appliance door (Fig. 7).
2. Remove both sieves from the bottom of the wash-tank.
Draining the Appliance
1. Remove the bottom sieves (Fig. 7).
2. Pull the overflow upwards (Fig. 9B).
3. Close the appliance door.
4. Select the dr program.
5. Start the program, by pressing the Start key (3).
The appliance executes the end cycle with auto-cleaning and switches off at the
end.
6. If needed, remove the drain sieve and clean it (Fig. 8C).
Switching the Appliance Off
1. Press the ON/OFF switch (1) to switch the appliance off.
Three central segments in the display (4) remain on and indicate available voltage.
110644
EN
23 / 32
Advertisement
Table of Contents
