Assembly & commissioning instructions
Instructions for assembly
Before unpacking the patient lifter, please make sure the package is not damaged. If that is the case,
immediately notify in written to the freight forwarder and contact SCALEO Medical.
These instructions for assembly concern the standard version of the Poweo
For the instructions of special models, please contact SCALEO Medical.
Please follow the instructions of this manual to properly assemble the patient lifter. If you
note any missing or defective piece, do not use the lifter; contact your distributor or SCALEO
Medical.
Using the Poweo
assemblage and
information.
Unpacking and assembling the Poweo
SCALEO Medical tests and charges all batteries before packing, however, the batteries must
be completely recharged before the first use.
Our lifters and batteries are always delivered with the emergency stop button on the "ON"
position. Always remember to release the emergency stop button on "OFF" position before
operating or charging the unit.
To start: Unpack the lifter by removing all protection devices and taking the lifter out of its carton
box.
Step 1: Install the actuator.
Install the actuator placing one end on the arm and one end
on the mast of the lifter, thanks to a hinge. Secure the
installation by introducing one spacer and fixing it with two
DOMU102_EN_8_20221201_ Poweo® 215-200 user manual
®
patient lifters requires a good understanding of transfer systems,
disassemble
procedures. Contact SCALEO Medical if you require further
®
lifters require two people.
®
200 and 215.
9