Scaleo medical Poweo 200 User Manual page 17

Charge
status
label
To charge the Linak® battery:
1. Connect the AC cable to the AC outlet,
2. The green «ON» light turns on,
3. The orange «CHARGE» light turns on, only if the battery is connected correctly.
To charge the SCALEO® battery:
1. Connect the charger to the AC outlet,
2. Place the battery in the battery charger,
3. Once the battery is detected in the charger, the LED indicator lights up.
Models including SCALEO® electronics take 2h30 to 5 hours to recharge 100% empty batteries.
Models including Linak® electronics take 8 to 10 hours to recharge 100% empty batteries.
For intensive daily use a daily recharge will be necessary.
The batteries cannot be overcharged. However, to ensure better performance and longevity, it
is recommended to let them rest for a few minutes after charging and before use. It is also
important to fully charge the battery.
Upon request, the charger's power connector can be delivered including a plug that ensures
additional protection of the charger against splashing water. Remove this plug for charging,
and be sure to replace it after recharging.
To charge the patient lifter, use only the supplied cable: charging a battery with an
unsuitable cable can cause the cable and/or battery to overheat and damage all
components, or cause a fire.
DOMU102_EN_8_20221201_ Poweo® 215-200 user manual
Emergency button
Battery label
Battery status
indicator
Emergency
button
Battery status
indicator
17